Chromed Leather Dyeing Peculiarities when Deliming with Peracetic Acid

Authors

  • Kęstutis BELEŠKA Kaunas University of Technology
  • Virgilijus VALEIKA Kaunas University of Technology
  • Justa ŠIRVAITYTĖ Kaunas University of Technology
  • Violeta VALEIKIENĖ Kaunas University of Technology

DOI:

https://doi.org/10.5755/j01.ms.19.2.4431

Keywords:

leather, peracetic acid, chroming, dyeing, adsorption, diffusion, kinetics, thermodynamics

Abstract

The research was aimed to investigate the influence of deliming with peracetic acid on leather dyeing kinetics. Hydrophobic C.I. Acid Red 213 and hydrophilic C.I. Acid Red 423 dyes were used. Sorption of dye depends on hydrophobicity/hydrophility of dye and dyeing temperature. Equilibrium of process is reached faster using hydrophobic C.I. Acid Red 213 at 45 ºC. However, both control and experimental leather fibres adsorb more hydrophilic dye C.I. Acid Red 423 and this fact does not depend on temperature. The diffusion coefficient of dye C.I. Acid Red 423 calculated according to Weisz model is higher when dyeing conventional leather. The change of deliming method has influence on chromed leather dyeing but this influence is not significant. The adsorption ability of control leather fibres at 30 ºC and 45 ºC is higher using both dyes as compared to the dyeing the experimental one. The increase of dyeing temperature increases the adsorption ability independently on the sort of leather fibres. Such dependence of the adsorption ability on the temperature shows that hydrophobic action and van der Waals forces prevail between dye and fibres during dyeing process. The Gibbs energy changes show that adsorption of both dyes by leather fibres independently on their sort is a spontaneous process. The affinity of both dyes to conventional leather fibres is higher comparing with experimental one. The change of enthalpy is positive in all cases, and it means that the driving force of the dyeing is the change of entropy.

DOI: http://dx.doi.org/10.5755/j01.ms.19.2.4431

Downloads

Published

2013-05-23

Issue

Section

POLYMERS AND COMPOSITES